For this BAP you will need
4 sheets of patterned paper
Photo mat or coordinating paper
Embellishments
Cut papers as follows
Leave one 12x12
1 ~ 9x12
1 ~ 6x12
1 ~ 10” circle silhouette and inside circle
1 ~ adhere the 9x12 onto the center of the 12x12
2~ adhere circle to the side of page then the 6x12 sheet onto the center of the 9x12
3 ~ adhere circle silhouette onto the outside edge of circle (like in the photo) add photo and mat (I used foam dots to add dimension)
4 ~ trim excess off (the circle)
5~ add your embellishments and title
Curly flower
I learned to make this flower from Craftbulee
To create this flower you will need
You can use the Tim Holtz tattered flower die or your cricut or your punches
3 ~ 2.5” 6 petal flower
2 ~ 2.5” 9 or 10 petal flower
Foam piece (from your brads works great)
Pencil
Skewer
Hot glue gun
1 ~ cut petals on all 3 of your 6 petal flowers a little closer to the center so it makes it easier to work with
2 ~ on ONE 6 petal flower, using your skewer, roll the petal BACK on both sides like this
3 ~ on your next two 6 petal flower fold petals in half
4 ~ leaving your fingers on the fold push the top of the petal back like a paper airplane - like this
5 ~ on your 10 petal flower…whatever color is on the bottom is the color you will see. Squeeze each petal together
6 ~ Using your skewer roll one of the petals forward, the next one back and continue until all your petals are rolled
7 ~ Using your foam block, place the first 6 petal flower (the one that looks similar to a star) then push down in the center.
8 ~ add glue to the center and the second flower and push down in the middle with your pencil. Repeat with the third flower
9 ~ add your first curly center but do not push down hard with your pencil
10 - add the second curly one and press hard
11 ~ fluff a little and you have your flower